24 Hour Emergency Service


403-279-2915

TD 134 Installation Options

Therm-O-Dor™ TD 134 offers a selection of customized options to meet virtually any application requirement. For additional information on how Steel-Craft can meet your needs in commercial overhead doors, please contact our office.


DOOR FACE

Optional upgrades to components that are connected to the door face.


  1. Graduated end hinge - available in increased gauge.
  2. Graduated double end hinge - available in increased gauge.
  3. Track rollers - available in a variety of formats to meet your specifications.
  4. Top fixtures - available in increased gauge.
  5. Low lift hardware
  6. Bottom corner bracket - available in increased gauge.
  7. Failsafe bottom corner bracket
  8. Locks - 2 point interior, 2 point exterior.
  9. Lift handle - 3 options available.
  10. Vision lite windows - sealed glass: 23"x7"; 24"x12"; 34"x16"; consult your dealer on the wide variety of glass options.
  11. Aluminum - available in full view section; consult your dealer about insert options (glass, polycarbonate - double or triple wall).
  12. Pass door
  13. Exhaust ports - available in various sizes.
  14. Strutting - to increase wind load capacity.
  15. Aluminum L retainer
  16. Specialty high moisture area conversions
  17. Increased gauge section face

GUIDE

Optional upgrades to components that are related to the door guide. All lifts are available in 2" or 3" track.


  • High lift - track and hardware that causes the door to rise vertically some distance above the top of the door opening before it levels out into a horizontal position. Available to meet a variety of height specifications.
  • Vertical lift - track and hardware that causes the door to open vertically where no horizontal tracks are required. Available to meet all height specifications.
  • Low lift double track - low headroom accessories which enable a door system to operate in minimal headroom conditions. Available to meet a variety of low headroom specifications.
  • Moveable center posts
  • Full angle mount - available in continuous and reverse (1" overlap).


LIFT

Optional upgrades to components that are related to the door lift.


  1. Torsion spring assembly - extensive cycle options are available to meet all specifications.
  2. Torsion shaft - available in 1" solid where 1" tube is specified.
  3. 1-1/4" solid shaft
  4. End bracket - 2-bolt flange bearing, available in 1" and 1-1/4".
Created by

Legal notice